Bella NutriRocket Manuel D'instructions page 11

5. Use the grinding tumbler to
process coffee, spices, hard
cheese, chocolate, special
flavored sugars, nuts and seeds.
To assemble for grinding or
whipping, using the blade's
collar to handle, place the
grinding (flat) blade into the
small tumbler.
IMPORTANT: Check to make
sure the tumbler ring is not
attached to the tumbler before
assembling the blade. If it is,
simply lift off to remove.
IMPORTANT: In the base of each
blade's collar, there is a plastic
gasket seal that creates an
airtight fit with the NutriRocket processing tumblers. After dishwashing
and before each use, always check to make sure the gasket is properly
in place, as the heat from some dishwashers may cause the gasket to
become loose.
WARNING: Never operate the NutriRocket Personal Blender when the
processing tumbler is empty.
WARNING: Never overfill the processing tumbler. Do not exceed the
MAX line.
6. Hold the tumbler (tall or small) firmly in one hand. Use the other hand to
tighten the tumbler/blade assembly by turning the blade collar clockwise
until snug.
7. Plug the power cord into a 120 V
AC electrical outlet.
8. Invert the processing tumbler/
blade assembly. Insert the blade
collar into the motor base, fitting
the tabs into the slots on the
motor base.
NOTE: The NutriRocket Personal
Blender will not operate unless
the 3 locking tabs on the blade
collar are properly fitted into the
3 slots on the motor base.
-310785_14022_13984 BELLA NutriRocket EFS IM.indd 7
7
Figure 3
Figure 4
2013-07-12 3:26 P