Publicité
Les langues disponibles
Les langues disponibles
Cleaning the brushbar and the nozzle
IMPORTANT: Always switch off the cleaner before changing and cleaning the brushbar.
If there are any obstructions or fine dust around the brushbar:
1.
Remove the nozzle from the tube. [15]
2.
Move the slider to the right and the nozzle window will pop open. [16a]
Fully open the nozzle window to remove the hybrid brushbar. [16a]
3.
4.
Hold the brushbar release end cap and remove the brushbar. [16b]
If there is remaining dirt in the brushbar, remove it manually or with the help of the cleaning tool. [16c]
5.
6.
If there is dirt inside the nozzle or around the comb, remove it by using the brush of the cleaning tool. [16d]
7.
To ensure nozzle is fully clear of any obstructions, turn the nozzle over and check along the bottom area. If
required, clean this area using the Hook of the cleaning tool provided. [16e]
8.
Turn the nozzle to the initial position and re-fit the brushbar. The brushbar can only fit in one direction and press
the end slightly to make sure the brushbar is in place. [16f]
9.
Close the window by pressing the middle area of window until you hear it "click" into place. Check the window is
completely locked by pressing on both sides. [16g]
Replacing the Batteries
This cleaner is fitted with a rechargeable lithium ion battery pack which is replaceable.
WARNING: Only use approved replacement parts for your cleaner. Using parts not validated by hoover are dangerous and
will invalidate your guarantee.
WARNING: Do not try to open the battery pack and repair it by yourself.
1.
Press the battery release buttons and pull the battery outside. [8]
2.
Removed the old battery pack and replace with the new battery pack.
3.
Dispose of the batteries safely. Used batteries should be taken to a recycling station and not disposed of with
household waste.
TROUBLE SHOOTING
Should you have any problem with the cleaner, follow this simple check list before calling the Hoover Customer Service
Centre:
A. Cleaner does not switch on
Check if the cleaner is charged.
Check if the battery pack is assembled in place.
B. Cleaner stop working
Check if there is an obstruction in air inlet or in the tube, clear it and ensure the product is OFF. Once this is done simply
press the on/off button, the product will start working again.
C. Loss of suction or no suction
Empty the dust cup and wash the pre-filter and separation system. [12, 13]
Remove nozzle and check for any blockages in the duct.
D. Batteries cannot be charged
This may be a result of very long storage periods (over half year).
Contact Hoover customer service to arrange battery replacement.
If the problem persists, contact the Hoover customer service center.
E. Brushbar Status LED is RED
There is a blockage in the nozzle or an obstruction to the brushbar. See Cleaner Maintenance section.
F. Brushbar Status LED and nozzle front LED lights are flashing WHITE
The nozzle window has not been completely closed.
If this happens, simply turn off your product and ensure the nozzle window is completely closed and switch on again.
8
GB
Publicité
