Composition; Safety Measures - Euroscaffold 190 Manuel De Montage Et D'utilisation

PROFESSIONAL WORK TENTS

3.2 COMPOSITION

EUROSCAFFOLD WORK TENT
Stanchion
Tarp 190
Tarp 250
Tarp 305
Connective strut 190
Connective strut 250
Connective strut 305
Horizontal strut 190
Horizontal strut 250
Horizontal strut 305
Spanfix
Double swivel joint

4. SAFETY MEASURES

Before you begin constructing or deconstructing the work tent, first read the safety measures below and follow all
instructions minutely. Incorrect construction of the scaffold and tent can result in dangerous situations that may
lead to accidents and severe bodily harm.
• Never attempt to construct or deconstruct the Euroscaffold work tent with fewer than two skilled people.
They must be skilled mechanics and be in good physical and mental condition.
• Use safety gloves, safety shoes and a helmet.
• Check whether all of the parts are present and in good condition. Any damaged or incorrect parts must
not be used. Only ever use original Euroscaffold work tent parts.
• Make sure that the scaffold with its stabilisers is set up on a sufficiently flat, level, sturdy surface capable
of bearing the joint load of the scaffold, work tent, and their loads. If the surface is a bit soft, use plates or
U-profiles underneath. If such aids are required, the stabilisers or side supports and ballasts must remain
mounted at all times.
• During the use and moving of the scaffold, ensure that no dangerous situations can occur, such as in the
event of extendable awnings, doors or windows opening, overhead cables, etc.
• Block the working area so that passers-by and traffic cannot enter, if the scaffold is on the public road.
• Do not use the Euroscaffold work tent when wind speeds exceed 6 on the Beaufort scale.
• Always anchor the scaffold when using the Euroscaffold work tent.
P OW E R E D BY K N OW L E D G E
190 250
2 2
1 -
- 1
- -
2 -
- 2
- -
1 -
- 1
- -
5 5
4 4
305
2
-
1
-
-
2
-
-
1
5
4
euroscaffold.com