Arrow ROT3200K-A Mode D'emploi page 16

Polishing:
Use the mandrel for polishing/wool wheel
1. Push the threaded point of the polishing/wool wheel
mandrel into the required polishing wheel.
2. Twist the mandrel anticlockwise to secure the polishing
wheel firmly on to the mandrel.
3. Fit the mandrel to the tool as described in "Fitting the
Attachments".
4. Occasionally check the wheel during use to ensure it is
still secure.
Cut off wheel and sanding papers:
Use the Mandrel for polishing/cut-off wheel
1. Push the threaded point of the Polishing / cut off wheel
mandrel into the required cut off wheel or sanding paper.
2. Twist the arbor anticlockwise to secure the cut off wheel or
sanding paper firmly on to the mandrel.
3. Fit the mandrel to the tool as described in "Fitting the
Attachments".
4. Occasionally check the cut off wheel or sanding paper
during use to ensure it is still secure.
16
ACCESSORIES
Sanding Drums:
Use the Sanding Drum Mandrel
1. To fit a disc to the Sanding Drum mandrel, unscrew the
fitting screw.
2. Remove the screw, washer and rubber drum holder.
3. Push the required Sanding Drum on to the rubber drum
holder.
4. Ensure that the drum is completely pushed on to the holder
so that edges of the drum and holder are aligned.
5. Replace the drum holder on the arbor.
6. Replace the washer and screw.
7. Tighten the screw until the disc is firmly secured.
8. Fit the mandrel to the tool as described in "Fitting the
Attachments".