Arrow ROT3200K-A Mode D'emploi page 10

is moving away from your hand, the possible kickback
may propel the spinning wheel and the power tool
directly at you.
• Allow brushes to run at operating speed for at least one
minute before using them. During this time no one is to
stand in front or in line with the brush. Loose bristles or
wires will be discharged during the run-in time.
• Direct the discharge of the spinning wire brush away
from you. Small particles and tiny wire fragments may be
discharged at high velocity during the use of these brushes
and may become imbedded in your skin.
10
SPECIFIC WARNINGS AND SAFETY RULES
FOR ROTARY TOOL
WARNING! To reduce the risk of injury in applications
that produce a considerable amount of dust, use an OSHA
compliant dust extraction solution in accordance with the
solution's operating instructions. Always use common sense
and be cautious when using tools. It is not possible to
anticipate every situation that could result in a dangerous
outcome. Do not use this tool if you do not understand these
operating instructions or you feel the work is beyond your
capability, contact Arrow Fastener or a trained professional
for additional information or training.
• Maintain labels and nameplates. These carry important
information. If unreadable or missing, contact Arrow
Fastener for a free replacement.
WARNING! Some dust created by power sanding,
sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or
other reproductive harm. Some examples of these chemicals
are:
• lead from lead-based paint
• crystalline silica from bricks and cement and other
masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how
often you do this type of work. To reduce your exposure to
these chemicals: work in a well ventilated area, and work
with approved safety equipment, such as those dust masks
that are specially designed to filter out microscopic particles.