JVC IF-C61HSDG Manuel D'instructions page 4

INSTALLATION
7
PREPARATION
• Wear gloves to protect your hands from metal parts on the Input Card's board.
• You will need a 6 mm Phillips screwdriver.
• Turn off the Monitor's main power and unplug the power cable from the AC outlet.
7
CAUTIONS
• Do not touch the terminals or board pattern of the Input Card to keep them from being damaged by
static electricity.
• Do not force the Input Card into the monitor's slot.
• Keep slot covers attached on the monitor's slots if they are not in use.
7
INSTALLATION PROCEDURE
1.
Unscrew the screws and remove
the slot cover from the slot (on the
rear side of the Multi-format
Monitor) in which the card is to be
installed.
2.
Insert the Input Card into the slot,
fitting the board into the guide rails
at the top and bottom of the slot.
3.
Push the Input Card in so that its
front panel touches the rear panel
of the Multi-format Monitor. (Hold
the tabs at top and bottom while
inserting the Input Card).
4.
Secure the Input Card by using the
screws removed in Step 1 above.
Make sure the Input Card is correctly
recognized by "SLOT CONDITION" on the
Main Menu of the Multi-format Monitor.
Example:
When the Input Card is installed to SLOT 1,
the conditions of INPUT A and INPUT B
become as follows:
INPUT A:HD/SD-1**
INPUT B:HD/SD-2**
2
Fit board to
guide rails.
Tab
Input Card
Tab
Slot cover
Rear side of the Multi-
format Monitor
Guide rails