Rohde ST 630 Mode D'emploi page 87

Step Activity
5 Turn the fuse holder anti-clockwise so that it
releases from the lock.
6 Remove the fuse carrier with the fuse from the
housing.
Insert a new fuse.
7
⇒ The fuse can be inserted in both directions.
8
Reinstall the fuse in reverse order.
Connect the control unit connection cable to the
9
kiln.
10 Switch on the kiln.
11 Switch the control unit on.
12 Check the control unit is working.
Remark
Tool:
7 mm slotted screwdriver
Fuse type:
5 x 20 mm / 3.15 A T micro-fuse
ROHDE item no.: 704851
Tool:
7 mm slotted screwdriver
Set the main switch on the kiln to the "I/ON" position or
plug in the power plug.
If the control unit still cannot be switched on, contact a
qualified electrician, the local specialist
or the manufacturer.
85 / 317 - EN -