Interface Properties; Inserting & Removing Usb Flash Drives; Data Transfer" Indicator - Rohde ST 630 Mode D'emploi

10.1.2.

Interface properties

General safety note:
PROHIBITION
Do not connect any other devices, except a USB flash drive, to this USB interface.
⇒ No devices such as cell phones or laptops may be plugged into this USB interface to
Description:
• USB versions 1.0 or 2.0 are suitable for recording the measured values.
• USB 3.0 is not compatible.
• The USB flash drive must be formatted to FAT32 or FAT16.
• NTFS format is not suitable.
• The data logger module has been tested with common USB flash drives of 8, 16 and 32 GB.
• The "USB flash drive plugged into USB port" indicator on the top of the housing confirms connection
with a compatible USB flash drive.
10.1.3. Inserting & removing USB flash drives
• The USB port (1) for inserting the USB flash drive is located
on the top of the housing, under an easily removable cover (2).
• Keep the USB port cover attached and plug it in when not in use.
• The USB flash drive may only be plugged into the controller or removed
when no data is being written to it.
• To insert and remove a USB flash drive, the controller does
not have to be switched off.
• The "USB flash drive plugged into USB port" indicator (3) on
the top of the housing goes out as soon as the flash drive is removed.
10.1.4.

"Data transfer" indicator

Display Description
The "data transfer" indicator flashes when information is being written to the USB flash drive.
charge the battery.
77 / 317 - EN -