Publicité
Les langues disponibles
Les langues disponibles
OPERATION
WARNING:
serious personal injury.
WARNING:
switched off.
SWITCH ACTION (FIG 3)
NOTE:
This tool has a safety feature on switch to prevent from accidently turning on.
first press the lock-off switch (1a) forward, then pull the power switch (1b) up to the "ON"
To Start the Tool,
position.
release the power switch (1b).
To Stop the Tool,
APPLICATION
GRINDING OPERATION
WARNING:
pressure. Forcing and excessive pressure could cause dangerous wheel breakage.
ALWAYS replace the wheel if the tool is dropped while grinding.
NEVER bang or hit the grinding wheel or disc onto the work.
Avoid bouncing and snagging the wheel, especially when working on corners, sharp
edges, etc. This can case loss of control and kickback.
NEVER use the tool with wood carving blades or other saw blades.
WARNING:
comes to a complete stop before putting the tool down.
ALWAYS select and use grinding wheels that are recommended for the material to be ground. ensure that the
maximum operating speed of any accessory selected for use is not exceeded by the RPM of this tool.
Turn the tool on and then apply the wheel or disc to the workpiece. The key to efficient operation begins by
controlling the pressure and surface contact between grinding wheel and the workpiece.
flat surfaces are usually best ground by keeping the edge of the wheel at an angle of 5 to 15 degrees.
Maintaining the proper angle of 5 to 15 degrees by tilting the grinder and continuously moving the grinder back
and forth or up and down over the work area. Keep the grinder moving to avoid removing a excessive amount of
material from one area.
Use just enough pressure to keep the tool from chattering or bouncing; normally the weight of the tool alone
is adequate for most grinding jobs. Where there is a chance that the grinding wheel may get snagged by the
workpiece, such as loose bolts or jagged edges, causing loss of tool control, use lighter pressure.
7" Angle Grinder
Operator's Manual
Failure to follow the safety rules stated in this manual may cause
Before plugging in the tool, always check to see that the tool is
1a
Never force the tool. The weight of the tool applies adequate
After operation, always switch off the tool and wait until the wheel
1b
FIG 3
GAG1570
Publicité
