Rumbleseat Assembly - UPPAbaby RumbleSeat 0252 Mode D'emploi

RUMBLESEAT ASSEMBLY

Prior to fitting adapters to stroller frame, engage brake on stroller and remove seat from frame.
ATTACHING ADAPTERS TO VISTA FRAME
STEP 1: Unsnap basket from front of stroller frame.
STEP 3: Hold outside of adapter and rotate over frame
to snap on. Repeat with second adapter on other side
of stroller frame.
NOTE: The adapters are left and right specific. Match
the colored dot to the coordinating color dot on the
stroller frame.
REMOVING ADAPTERS FROM VISTA FRAME
5
0252_RUMBLESEAT_Instructions_V7.indd 5-6
STEP 2: Line up top of adapter with basket snap
bumper guide.
STEP 4: Re-snap basket to frame.
Grab tab with fingertips and rotate off frame. Repeat
with second adapter on other side of stroller frame.
RUMBLESEAT ASSEMBLY
ATTACHING RUMBLESEAT TO VISTA FRAME
To Attach Seat: Lower RumbleSeat onto adapters in forward or reverse
position and press down until it clicks into place. Pull up on seat to
ensure it is locked to frame.
ATTACHING/REMOVING THE BUMPER BAR
STEP 1: Insert metal posts into bumper bar
attachment slots found on both sides of seat.
NOTE: Bumper bar should not be used without the bumper bar cover.
CANOPY INSTALLATION
STEP 1: Pull canopy fabric over seat back recline
button.
To Remove Seat: Simultaneously
push down release buttons
and lift seat from frame .
STEP 2: To remove, press button at bottom of plastic
housing and lift bumper bar out.
STEP 2: Snap each side of canopy attachment to
seat frame.
9/17/15 1:21 PM
6