Makita PB002G Manuel D'instructions page 5

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Max. cutting capacity
Blade speed
Blade size
Dimensions (L x W x H) with BL4040
Rated voltage
Net weight without wheel cover
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of
residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.
Intended use
The tool is intended for cutting in plastic and ferrous
materials.
Noise
The typical A-weighted noise level determined accord-
ing to EN60745-2-20:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Round workpiece
Rectangular workpiece
Length
Width
Thickness
) : 78 dB(A)
pA
510 mm x 218 mm x 314 mm
D.C. 36 V - 40 V max
BL4020* / BL4025* / BL4040* / BL4050F / BL4080F
* : Recommended battery
DC40RA / DC40RB / DC40RC
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN60745-2-20:
Work mode: cutting metal
Vibration emission (a
Uncertainty (K) : 1.5 m/s
5 ENGLISH
PB002G
127 mm dia.
127 mm x 127 mm
0 - 3.2 m/s
(0 - 192 m/min)
1,140 mm
13 mm
0.5 mm
6.6 - 7.8 kg
2
) : 2.5 m/s or less
h,M
2