Cleaning Of The Toe Kick Cover And Condenser - F.Bertazzoni WC5B2T Serie Mode D'emploi

9.2 Cleaning of the toe kick cover, filter
and condenser
The unit requires, for a correct operation, the
cleaning of the toe kick cover, filter and
condenser.
It is recommended to perform the following cleaning
steps very 6 months. An audio and visual message
on the display will serve as a reminder. It is possible
to disable the warning signal and see the time left
before the next cleaning has to be done.
Behind the frontal toe kick cover is the condenser.
To clean it use a vacuum cleaner with a soft
brush attachment at maximum power, sweeping
it along the vent slits. In case of a significant
dust build up, the toe kick cover can be removed
to allow a more accurate cleaning of the filter.
On the mantenience settings,
installation of the unit and after it has been turned
on, you can set the condenser cleaning warning.
In the case the warning sign is enabled, there will be
an audible signal every 6 months, alerting that it is
time to clean the condenser.
After cleaning it, touch the reset icon in order
to reactivate the warning signal in 6 months.
If you do not want the cleaning signal alert for the
condenser, touch the Off icon.
Lower condenser
For cleaning the condenser follow the
instructions:
> Switch off the appliance by pressing the Unit
button
seconds.
> Wait approx 30 minutes, until the finned
condenser cools down to room temperature.
> Remove the removable grille under the door.
Maintenance Service
after the
Info System
> Clean it thoroughly of any dust build up as shown in
the picture, taking care not to damage the condenser.
> Restart the unit again, pressing on the unit button
for three second.
on the main control panel for approx 3
Warning
The edges of the condenser are sharp,
therefore use adequate protection for
hands and arms when cleaning the
condenser.
EN
27