Stopping; Using Detergent - Wilks USA TX750 Mode D'emploi

TX750 / TX750i

Stopping

OFF
Turn the engine switch to the off
position
Note: make sure you depress the trigger on the gun to fully drain any residual water left in the system.
Failure to do so can result in damage due to corrosion or water expansion when freezing.

Using detergent

01. Open the front cap on the detergent tank and fill with a suitable pressure washer detergent. Do
not use washing up liquid as it contains salt.
02. Fit the blue / black nozzle to the end of the lance.
03. Suction and mixing will occur as water flows through the pump. You may be required to fit the
shorter of the supplied hoses in conjunction with the blue / black nozzle to create the required
pressure to draw detergent.
Note: a thick viscous detergent will not flow freely from the
detergent tank and the residue is likely to cause a
blockage in the system. After using the detergent facility it
should be flushed thoroughly with clean water to remove
any trace of detergent.
8
Turn the fuel tap off by sliding to
the left
© Wilks-USA
English
Turn the water supply off