Wilks USA TX750 Mode D'emploi page 5

TX750 / TX750i
Assembly
Locate the axle holes on the
underside of the frame. Insert
the axle so the sprung clip locks
in place
Push the handle in place by
inserting both sides evenly into
the frame so the sprung catches
click into the holes
Slide the wheel over the axle and
secure with the nut.
The nozzle panel is fixed in place
with four long nuts and bolts
© Wilks-USA
English
For TX750i model only: Slide the
hose reel and bracket over the
handle section and secure with
four nuts and bolts taking care
not to over-tighten the brackets.
Attach the crank handle
5