Bosch EasyGrassCut 18V-230 Notice Originale page 25

Charger
Protection class
Noise/Vibration Information
Noise emission values determined according to EN 62841-4-4.
Typically the A-weighted noise levels of the product are:
– Sound pressure level
– Uncertainty K
– Sound power level
– Uncertainty K
Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 62841-4-4
– Vibration emission value a
h
– Uncertainty K
Mounting and Operation
Action
Product features
Delivery scope
Removing the transport safety
Connecting the shaft
Adjusting the handle
Mounting the protection guard
Battery charging and inserting
Switching On and Off
Switching from lawn trimming/
edge cutting
Removing the line spool
Winding line on spool
Mounting the line spool
Line feeding
Maintenance, Cleaning and Stor-
age
Accessories
Assembly
Caution: Switch the garden tool off and pull the mains
u
plug before performing any maintenance.
Connect shaft (see figures C and D)
Note: A connected shaft can no longer be dismounted.
Remove the transport safety (9).
Connect the individual parts of the shaft until they can be
heard to engage.
Bosch Power Tools
AL 1810 CV AL 1820 CV
/ II
dB(A)
dB
dB(A)
dB
2
m/s
2
m/s
Mounting and adjusting the handle (see figure E)
The handle (1) can be set to different positions. To change
Figure Page
the adjustment, press buttons (7) and move the handle to
the desired position. Release the buttons (7) again so that
A 431
the handle can engage.
B 432
C 432 Mounting the protection guard (see figure F)
D 433
Before mounting the protective guard, pull the plant-protec-
tion frame from the delivery position to the storage position.
E 433
Position the protection guard (8) on the trimmer head and
F
434
fasten it with the provided screw.
G 435
Do not disassemble guard once connected.
H 435
Then, pull the plant-protection frame to the working posi-
I 436 tion.
Switching on
J 437
K 437
Caution: Switch garden tool off and remove battery
u
L 438
from machine before adjusting or cleaning.
The cutting line continues to rotate for a few seconds
M 438
u
after the trimmer is switched off. Allow the motor/cut-
N 439
ting line to stop rotating before switching on again.
Do not briefly switch off and on again several times in
u
O 440
a row.
Only use Bosch approved cutting elements. Cutting
u
performance will vary with different cutting elements.
Charging the Battery
The battery is equipped with temperature monitoring that al-
lows charging only in the temperature range between 0 °C
and 35 °C. In this manner, a high battery service life is
achieved.
Note: The battery is supplied partially charged. To ensure
full battery capacity, completely charge the battery in the
battery charger before using for the first time.
AL 1830 CV
/ II / II
3 600 HC1 A..
72
= 2.5
80
= 1.0
< 2.5
= 1.5
F 016 L94 299 | (22.07.2021)
English | 25
AL 1880 CV
/ II
3 600 HC1 C..
74
= 2.5
82
= 1.0
< 2.5
= 1.5