Operating Messages; Error Codes - Tintometer Lovibond MD100 Mode D'emploi

Operating messages – Error codes
GB
Hı
Lo
btLo
E27 / E28 / E29
E 10 / E 11
E 20 / E 21
E23 / E24 / E25
E 22
E 70
E 71
MD100_5 10/2014

Operating messages

Measuring range exceeded or excessive turbidity.
Result below the lowest limit of the measuring range.
Replace batteries, no further tests possible.
Battery capacity is too low for the display backlight;
measurement is still possible.

Error codes

Light absorption too great. Reasons: e.g. dirty optics.
Calibration factor "out of range"
Too much light reaching the detector.
Too much light reaching the detector.
Battery capacity was too low during measurement. Change battery.
F: Factory calibration incorrect / erased
F: User calibration incorrect / erased
27