Assembly; Cleaning The Motor Unit, Aluminium Suction Tube And Nozzles; Cleaning The Led Motorised Brush; Storage - TechniSat TECHNIMAX AS1 Notice D'utilisation

Table des Matières

Les langues disponibles

9.1.1 Assembly

Place the pre-filter on the HEPA filter so that the catch is in the recess

provided. Turn the dust filter clockwise until it is firmly seated.

Insert the pre-filter and HEPA filter into the dust holder. The dust filter must

be seated correctly in the dust holder; it must not protrude from the top.

Reinsert the dust holder in the motor unit.

Wipe the motor unit, the aluminium suction pipe and the nozzles with a

damp, soft cloth as necessary. Dry with a soft cloth.

Regularly remove hair and lint from the nozzles and brushes.

For easier cleaning, the roller can be removed from the LED motorised brush:

On the right side of the LED motorised brush, slide the lock (lock symbols) to

the open lock position and remove the retaining bracket.

Pull out the roller and remove contaminants.

Insert the roller in the reverse order, insert the retaining bracket and press

down until it engages audibly.

Store the device in a cool, dry place away from direct sunlight and out of

reach of children and animals.

For storage, hang the device in the wall bracket/stand with the suction

opening pointing downwards.

The 2-in-1 combination nozzle and crevice tool can be attached to the side of

the wall bracket/stand for easy and space-saving storage.

If the device is not to be used for an extended period of time, remove the

battery from the motor unit and charge the battery before next use.

If the device does not work properly, check if you can solve the problem yourself.

If the steps below do not solve the problem, contact customer service ("4.5 Service

information" on page 31).

Table des Matières

Table des Matières