Usage - TechniSat TECHNIMAX AS1 Notice D'utilisation

> Connect the battery (9) to the motor unit by pushing the battery onto the
motor unit until it engages audibly.
> Insert the mains adapter plug (DC connection) into the connection socket (11)
on the battery and then plug the mains adapter into the socket. The charging
indicator light on the battery flashes red and the battery status display on the
touch display shows the charging status in %. The battery is charging.
> If the charging indicator lights green or if the battery status indicator is at
100, the battery is fully charged.
> First disconnect the mains adapter from the mains, then disconnect the DC
connector from the battery.
The charging electronics in the battery have overheating protection that
protects the battery from defects. If you try to charge the battery after a long
period of continuous use (battery power is at 0 - 10 %), the charging process
may start only after a delay.
> To remove the battery from the motor unit, first press the release button (10)
on the battery and simultaneously pull the battery forwards off the motor
unit.

8 Usage

Make sure that there are no large, sharp objects on the surface to be cleaned.
Take note of the MAX mark on the dust holder. If the mark is reached during
use, empty the dust holder. Empty and clean the dust holder after each use.
The filters must also be cleaned regularly to avoid overloading the motor.
36