TechniSat TECHNIMAX AS1 Notice D'utilisation page 30

- In the interest of your own safety, check the device for damage before each
use. Use the device only if it is undamaged! If the device or the connecting
cable are damaged, they must be replaced by the manufacturer, customer
service or a similarly qualified person (e.g. a specialist workshop) in order to
avoid hazards.
Risk of material damage
- Ensure that the mains cable is not crushed, bent or laid over sharp edges and
does not come into contact with hot surfaces.
- Do not wind the mains cable around the device or the mains adapter.
- Use the device if it has been fully and correctly assembled. The dust holder
and the filters must be inserted and be undamaged! Damage to the motor
could occur if dirt were to get inside the motor unit.
- Unplug the mains adapter if a fault occurs during charging or before a
thunderstorm.
- The device must be switched off when the mains adapter is unplugged from,
or plugged into, a socket. Always pull on the mains adapter and never on the
mains cable to disconnect the device from the mains!
- Do not use the device if it is still connected to the mains adapter.
- Never pull or carry the device by the mains cable.
- Keep the device away from heat, naked flames, extreme temperatures,
prolonged humidity, moisture and knocks.
- Use original accessories only so as not to impair operation of the device and
to prevent potential damage. The LEDs are not replaceable.
30