Technical Specifications; Putting The Machine Into Service - Grillo X TRIMMER Manuel D'utilisation

TRIMMER-Translation of the original instructions

TECHNICAL SPECIFICATIONS

ENGINE: BRIGGS & STRATTON 575EX, OHV, 140cc, 3 HP (Net power SAE J 1349 Kw 2,27),
one-cylinder, four stroke, petrol engine; silenced muffler; paper air filter
STARTER: recoil starter with Ready Start device
FUEL TANK: 0,8 litres
CUTTING HEIGHT: adjustable in 2 positions (45 – 57 mm)
CUTTING WIDTH: 450 mm
CUTTING HEAD: fixed
WHEELS AXLE: fixed
WHEELS: Ø 250 mm
STANDARD FEATURE: adjustable side grass-guard baffle
WEIGHT: 30 kg

PUTTING THE MACHINE INTO SERVICE

- Check that the machine has not been damaged in transit.
- Fit the front grass protection.
- Fit the handlebar and adjust its inclination
- Fill in the engine oil (see engine manual)
- Fill up the petrol tank. Use a funnel with a very fine filter.
Before starting the engine always check:
- the oil level inside the engine. The level cap is on the top casing (fig. 3) and the oil level must be
between the two rims.
- that all nuts and bolts are firmly tightened.
- that all levers are in neutral position.
- that the air filter is clean.
- fill the tank with fuel using a funnel with a very fine filter. Once the engine has started, accelerate
gradually. Allow the engine to warm up for a few minutes before starting work.
7