Bluetooth Playback - Renkforce T21 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

c) Bluetooth playback
The amplifier supports Bluetooth, allowing you to stream audio from a Bluetooth device. Before streaming
audio, follow the instructions below to pair your audio device with the amplifier.
Pairing
• Switch the amplifier on.
• Press the volume control wheel (8) or the MODE button (14) on the remote control and set the audio input to BT.
• The BT LED on the audio input indicator (4) will flash quickly, indicating that the amplifier is not paired with a
Bluetooth device.
• Turn on your Bluetooth device and enable Bluetooth (refer to your device's instruction manual for details).
• Search for nearby Bluetooth devices.
• Select "BT Speaker" from the list of available devices.
• Connect your device to the amplifier.
• If you are prompted to enter a password, enter 0000.
• Once the devices have been paired, the BT LED (4) on the audio input indicator will stay constant/flash slowly.
• If the devices failed to pair, repeat the above steps. You may need to delete the amplifier from the list of Bluetooth
devices (refer to your device's instruction manual for details).
You can only pair one Bluetooth with the amplifier at any one time. If the amplifier is already paired with
another Bluetooth device, the existing connection must be disabled via the device's Bluetooth menu.
The Bluetooth connection will be interrupted if the devices move out of range, or if you switch off the am-
plifier and/or Bluetooth device. The connection will be automatically re-established when the devices are
switched on and within range.
Ensure that you enable the automatic reconnection feature on your Bluetooth device, otherwise the
Bluetooth connection will not be automatically re-established (refer to your device's instruction manual for
details).
Playback
• Press the
button (6) on the amplifier or remote control to start or stop playback.
• Press the
button (5) on the amplifier or remote control to skip to the previous song.
• Press the
button (7) on the amplifier or remote control to skip to the next song.
28

Publicité

Table des Matières

Dépannage

loading

Table des Matières