Controls - Kärcher BRC 46/76 W Mode D'emploi

RECOVERY
DRAIN HOSE
SOLUTION
HOSE
SEE BELOW
1. Brush/Vac Shoe Lift Lever - Raises and lowers both
2. Electrical Cord
3. Main Power Switch – Turns On and Off the vac
4. Brush/Solenoid Knob – Enables the brush motor
5. Speed Control Knob – Adjusts the forward drive
6. Drive Motor Circuit Breaker – 6 amp, protects the
7. Vac Motor Circuit Breaker – 15 amp, protect
8. Brush Motor Circuit Breaker – 8 amp, protect brush
9. Solution Accessory Tool Hook-Up – Used for
10. Main Handle
11. Vacuum Accessory Tool Hook-Up – To use
12. Vac Shoe Assembly
DRIVE CONTROLS
A. The speed the machine will travel is regulated by the
B. Squeezing the control lever will propel the machine
C. To move the machine backwards release the control
86309220 BRC 46/76 W 02/18/08
brush and vac shoe.
motor/pump and machine.
and solution spray (only when propelling).
speed of the machine. (See Below)
drive motor mechanism.
vacuum motor.
motor.
various auxiliary cleaning tools.
accessory tool, remove hose from vac shoe and
attach to accessory tool adaptor. 86089080 (PRV
NO.78211)
knob located on the center of control panel. Turn the
knob to the right to increase the speed of the machine
and to the left to decrease the speed of the machine.
forward at the selected speed. Machine will also
engage the brush and spray if #4 is activated.
lever and then pull back on main handle
(NOTE: The machine drive assembly is disengaged).
Do not pull back on the control lever.

CONTROLS

7