Warnings; Assembly Instructions - RELAXXNOW VTX100 Mode D'emploi

• This product is for personal use only.
• Any maintenance beyond standard care of the product should be performed
by an authorized professional
• Do not immerse the device in water.
• Do not remove any parts and do not remove the wiring or tamper with the
electrical system
• to avoid the risk of fire or electric shock.
• The product should only be repaired by an authorized specialist.
• If the power system of this unit is damaged, it must be replaced by the ma-
nufacturer or the responsible customer service provider or a similarly qualified
person in order to avoid hazards.

ASSEMBLY INSTRUCTIONS

Installation and use
1. Mount and connect the socket unit with the support tube. Open the case and
remove the socket.
Then assemble the tubes, the larger tube being the bottom tube and the smaller
tube connecting to the switch unit.
Align the four holes in the tubes and tighten the screws. Slide on the decorative
cover.
Place the base next to the support tube and secure the support tube to the base
unit. Then tighten the outer joint.
2. Mount propeller:
1) Connect the protective cover and the cover ring and attach the rear cover to the
engine. (Observe the direction of rotation)
Lay the connection of the cover ring down and connect the deep screw of the
cover ring with the circular side ring of the rear side of the unit. Then tighten the
screws for the correct position of the connection with the nut.
20 Relaxxnow

WARNINGS