Techno Line WS6767 Mode D'emploi page 15


Indoor/Outdoor temperature / humidity Min/Max records

Selected channel

Location selection

Temperature alert

Frost Alert
Batteries ：
Receiver （WS6767） ：2XAA
Sensor（TX960-TH） ：2XAAA
Full LCD Display：
Quick Setup：
Step 1： Open the battery compartment of outdoor sensor. Insert 2 x AAA LR03 batteries (not included) into the TX960-TH
sensor. Observe the correct polarity. Close the battery compartment of outdoor sensor.
Step 2：Open the battery compartment of weather station. Insert 2 x AAA LR06 batteries (not included) into the weather
station.Observe the correct polarity. The red LED will flash during transmission. Close the battery compartment of weather
station.
Restart: If there is no outdoor temperature and humidity data after 3 minutes, remove the batteries from station and out
sensor for 15 minutes then return to step 1above.
Power On：
1. Display full segment for 3 seconds.
2. The weather station starts searching wireless sensor via 433MHZ.
3. If outdoor temperature is not displayed after 3 minutes, hold the "CH" button on the main until to search for outdoor
sensor.Then press "TX" button on the sensor to send signal.If it still does not receive the outdoor temperature ,remove the
batteries from transmitter and go back to step 1 of the set up.
EN 2