TWP passive transmitter setup:
It is possible to attenuate the output video signal (on the terminal for twisted cable) setting the dip switches
according the values on the table. This function can be required in case of short distances, with receiver input
signal levels too high and with risk of saturation.
Dip position:
Note: in case of using the TWP as passive receiver, set all dip switches to "ON" position.
Dip1
Dip2
ON
ON
OFF
ON
OFF
OFF
OFF
OFF
Dip3
V terminal output
ON
Vout (twisted)= V in (coax) x 1.15
ON
Vout (twisted)= V in (coax) x 1.15 / 2
ON
Vout (twisted)= V in (coax) x 1.15 / 3
OFF
Vout (twisted)= V in (coax) x 1.15 / 4
Pag. 5
MNVCTW_0610