Installation Instructions - Cafe CVW9304 Manuel De L'utilisateur Et Instructions D'installation

If you have questions, visit us at cafeappliances.com or visit our website at: cafeappliances.ca.
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT
■
instructions for local inspector's use.
IMPORTANT
■
codes and ordinances.
■
Note to Installer – Be sure to leave these
instructions with the Consumer.
■
Note to Consumer – Keep these instructions for
future reference.
■
Skill level – Installation of this vent hood requires
basic mechanical and electrical skills.
■
Completion time – Approximately 1 to 3 hours
■
Proper installation is the responsibility of the
installer.
■
Product failure due to improper installation is not
covered under the Warranty.
CAUTION
Due to the weight and size of these
vent hoods and to reduce the risk of personal injury
or damage to the product, TWO PEOPLE ARE
REQUIRED FOR PROPER INSTALLATION.
FOR YOUR SAFETY
WARNING
Before beginning the installation,
switch power off at service panel and lock the
service disconnecting means to prevent power from
being switched on accidentally. When the service
disconnecting means cannot be locked, securely
fasten a prominent warning device, such as a tag, to
the service panel.
1" = 2.5 cm; 1' = 0.3 m
49-2000706 Rev. 3

Installation Instructions

— Save these
— Observe all governing
WARNING
TO REDUCE THE RISK OF FIRE,
ELECTRIC SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Installation work and electrical wiring must be
done by qualified person(s) in accordance with
all applicable codes and standards, including
fire-rated construction.
B. Sufficient air is needed for proper combustion and
exhausting of gases through the flue (chimney) of
fuel burning equipment to prevent back drafting.
Follow the heating equipment manufacturer's
guidelines and safety standards such as those
published by the National Fire Protection
Association (NFPA), the American Society for
Heating, Refrigeration and Air Conditioning
Engineers (ASHRAE) and the local code
authorities.
C. When cutting or drilling into wall or ceiling, do
not damage electrical wiring and other hidden
utilities.
D. Ducted fans must always be vented to the
outdoors.
E. Turn off breaker to adjacent rooms while working.
WARNING
TO REDUCE THE RISK OF FIRE,
USE ONLY METAL DUCT WORK.
WARNING
Disconnect all electrical power at
the main circuit breaker or fuse box before installing.
9