Cafe CVW9304 Manuel De L'utilisateur Et Instructions D'installation page 13

DUCT COVER REQUIREMENTS
Duct cover kits must be purchased separately.
We recommend that the vent hood and duct cover
(if used) be on site before final framing and wall
finishing. This will help to accurately locate studs,
ductwork and electrical service.
• Duct cover accessory comes with a lower and
upper duct cover and installation hardware.
• The installation hardware includes mounting
brackets to secure duct covers to the wall.
• For vented installations, recirculation holes can be
hidden by installing the upper duct cover upside
down.
• See table below for duct cover kit part numbers
based on finish.
Model # Duct Cover Kit #
CX8DC9SPDS
30" & 36"
Model (Matte CX10DC9SPDS
Black)
CX12DC9SPDS
CX8DC9SPWM
30" & 36"
Model (Matte CX10DC9SPWM
White)
CX12DC9SPWM
NOTE: Duct Cover Kits CX8DC9SPDS and
CX8DC9SPWM only support vented installation
mode.
1" = 2.5 cm; 1' = 0.3 m
49-2000706 Rev. 3
Installation Preparation
Max Ceiling
Installation
8' 4"
11' 1/4"
13' 4"
8' 4"
11' 1/4"
13' 4"
INSTALLATION DIMENSIONS
The hood duct covers can be adjusted for different
ceiling heights depending on the distance between
the bottom of the hood and the cooktop (distance
X). See Installation Height Table on the next page.
5" min
27" max
19-1/2"
18"
Required Min & Recommended Max Ceiling Height
Examples for 10' Duct Cover Kit (Vented)
Electric Gas
X = 24" X = 30"
Y = Min 8' 2" Y = Min 8' 10"
X
Max 9' 10"
X = Distance from hood to cooktop. (Varies
depending on the installation) Required 24"
minimum over electric range or 30" minimum over
gas range. The recommended maximum is 36".
36" Typical Range
or
38"
NOTE: 36" for typical electric range
and 38" for gas range.
Upper Duct
Cover
Lower Duct Cover
Y
X = 36"
Y = Min 9' 4"
Max 10' 6" Max 11' 0"
13