Operation - Tineco PWRHERO 11 Serie Mode D'emploi

Masquer les pouces Voir aussi pour PWRHERO 11 Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.Install the wall-mounted dock to the wall with
the nails provided by Tineco.
Fig.C-9
• Determine the best wall location for mounting
the dock. We recommend placing it 47.25"
(120cm) from the lower screw hole to the floor
(may need to be adjusted based on the actual
situation).
Fig.C-10
Warning:
• Ensure the wall surrounding the mounting area
is free of gas, water pipes, electrical cables and
wires.
• To avoid the dock falling, ensure it is firmly
installed.

OPERATION

Preparing for Use
Note:
• Before the first use, please charge the
appliance (see "Charging the Battery") for
4-5 hours in an area where the ambient
temperature is between 39.2°F (4°C) and
104°F (40°C).
• Select an accessory and attach it to the
appliance before use (see "Accessories").
1.Pull the trigger to activate the suction. Pull the
trigger lock to hold the trigger for continuous
power mode.
Fig.D-1
2.Press
to enter Medium mode, and press
it again to enter MAX mode. From MAX mode,
press
to return to Low mode.
Low mode: one indicator light illuminated
Medium mode: two indicator lights illuminated
MAX mode: all indicator lights illuminated
Fig.D-2
• Place the appliance on the wall-mounted
dock for convenient storage after use.
1.Place the main body on the dock.
Fig.D-3
2.To avoid bristle damage, always place
attachments on the dock after use.
Fig.D-4
Emptying the Dustbin
1.Press the release button on the side of the
dustbin to empty the contents.
Fig.D-5
2.Close and click the dustbin flap back into
place.
Fig.D-6
Charging the Battery
• Place the main body with the battery on
the charging dock, plug in the adaptor and
charging port, the blue light blinking shows
charging correctly.
• Or charge the battery separately: open the
cover above and put the battery in the upper
groove, then plug in the adaptor and charging
port, the blue light blinking shows charging
correctly.
Fig.D-7
Note:
• If you need a spare battery, please purchase
from Tineco.
Warning:
• Only use the Tineco-provided adapter to
charge the battery.
• During long periods of not being used, store
the lithium battery in a cool, dry place. Ensure
the battery is fully charged every 3 months.
• Store appropriately indoors in a dry place. Do
not expose appliance to sunlight or freezing
temperature. Recommended temperature
range: 39.2°F (4°C)~104°F (40°C).
Runtime
• Low/Med/Max mode:
~40 mins/19 mins/12 mins
*Actual runtime depends on the quantity and
capacity of the battery.
• Estimated runtime data was obtained by a
Tineco Laboratory using one battery and non-
motorized accessories.
11

Publicité

Table des Matières
loading

Table des Matières