Panasonic S-E70200 Manuel D'utilisation page 25

1
Align mark A ( ) on
the lens hood with the
mark on the tip of the
lens.
2
Rotate the lens hood in
the direction of the
arrow to align mark B
( ) on the lens hood
with the mark on the tip
of the lens.
Attach the lens hood by
0
rotating it until it clicks.
∫ Removing the lens hood
While pressing the lens
hood button C, rotate the
lens hood in the direction
of the arrow and then
remove it.
Note
When carrying, the lens hood can be attached in the
0
reverse direction.
1 Remove the lens hood.
2 Align mark B (
on the tip of the lens.
3 Attach the lens hood by rotating it in the direction of
the arrow until it clicks.

It is recommended to remove the lens hood during
0
flash photography as the lens hood can block the light
from the flash.
To prevent dropping of the lens, you should never carry
0

the lens by just holding the lens hood.
∫ Notes on filter use

It is possible to attach the lens cap or the lens hood
0
with the filter already attached.
There may be some vignetting in recorded images if
 0
multiple filters are attached simultaneously.
It is not possible to attach any items other than filters
0
such as a conversion lens or adaptor to the front of the
lens and use it in combination with this lens.
Lens damage may result if such items are attached.
) on the lens hood with the mark
DVQX1999
(ENG)
25