Publicité
Les langues disponibles
Les langues disponibles
ADJUSTING THE TENSION
Chain tension is very important. Chains stretch during
you use your saw. Always check chain tension each
time before you start the chain saw.
the clutch cover.
Turn adjustment screw clockwise until chain solidly
contacts bottom of guide bar rail.
3. Using bar tool, roll chain around guide bar to
ensure all links are in bar groove.
4. Lift up tip of guide bar to check for sag. Release tip
While lifting tip of guide bar, tighten bar nuts
securely with the bar tool.
FUELING ENGINE
a WARNING: Remove fuel cap slowly when
refueling.
DO NOT USE automotive oil or marine oil. These oils
instructions printed on container. Once oil is added to
gasoline, shake container momentarily to assure that
the safety rules relating to fuel before fueling your unit.
days to assure fuel freshness.
CAUTION: Never use straight gasoline in your unit.
This will cause permanent engine damage and void
the limited warranty. Do not use alternate fuels such
fuels can cause major engine performance and
durability problems.
Gasoline, gallons
8
FUEL HANDLING
Two-stroke oil, ounces
6. Use the screwdriver end of the bar tool to move
chain around guide bar.
7. If chain does not rotate, it is too tight. Slightly
loosen bar nuts and loosen chain by turning the
Retighten bar nuts.
If chain is too loose, it will sag below the guide bar.
DO NOT operate the saw if the chain is loose.
NOTE: The chain is tensioned correctly when
the weight of the chain does not cause it to sag
below the guide bar (with the chain saw sitting in
around the guide bar.
a WARNING: If the saw is operated with
a loose chain, the chain could jump off
the guide bar and result in serious injury
to the operator and/or damage the chain
making it unusable. If the chain jumps off
the guide bar, inspect each drive link for
damage. Damaged chain must be repaired
or replaced.
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubrication.
Lubrication is provided by the automatic oiler system
ruin the bar and chain.
Too little oil will cause overheating shown by smoke
coming from the chain and/or discoloration of the
bar. In freezing weather oil will thicken, making it
necessary to thin bar and chain oil with a small
pump enough oil for adequate lubrication.
Bar and chain oil is recommended to protect your unit
and chain oil is not available, use a good grade SAE
Never use waste oil for bar and chain lubrication.
Always stop the engine before removing the oil cap.
Publicité
