Publicité
Les langues disponibles
Les langues disponibles
RESETTING THE CHAIN BRAKE
If the clutch cover is removed accidentally while
the chain brake is locked, the chain brake must be
unlocked so the clutch cover can be assembled
without binding to the clutch drum.
the brake rotating link.
Perform the following steps after each use:
Allow the engine to cool, and secure the unit before
storing or transporting.
Store chain saw and fuel in a well ventilated area
where fuel vapors cannot reach sparks or open
switches, furnaces, etc.
Store chain saw with all guards in place and
position chain saw so that any sharp object cannot
accidentally cause injury.
Store chain saw well out of the reach of children.
SEASONAL STORAGE
Prepare your unit for storage at the end of the season
If your chain saw is to be stored for a period of time:
Clean saw thoroughly before storage.
Store in a clean dry area.
Oil the chain and wrap it in heavy paper or cloth.
FUEL SYSTEM
Under FUELING ENGINE in the OPERATION section
of this manual, see message labeled
chain saw.
Fuel stabilizer is an acceptable alternative in
minimizing the formation of fuel gum deposits during
storage. Add stabilizer to the petrol in the fuel tank or
fuel storage container.
stabilizer.
ENGINE
engine oil through the spark plug opening. Slowly
Replace spark plug with new one of recommended
type and heat range.
Check entire unit for loose screws, nuts, and bolts.
Replace any damaged, broken, or worn parts.
18
CAUTION: The chain brake spring is under tension.
Use care when resetting the brake.
To reset the brake, rotate the link clockwise until
it stops. NOTE: do not hold the brake band while
attempting to reset it.
The front link will be in its downward rotated position
when the chain brake is unlocked.
STORAGE
fuel having the proper petrol to oil ratio.
OTHER
Do not store petrol from one season to another.
Replace your petrol container if it starts to rust.
Publicité
