Ignition - Propane Gas Operation; Do A Test Of The Gas Safety Valve - Norcold 323 Manuel Du Propriétaire

Ignition - propane gas operation:

Do not us a match for ignition. An ignition flashback can cause burns to the hand or face. If, in an
!
emergency, you must use a match for ignition of the refrigerator, do not hold in the gas control for more
WARNING
than five or ten seconds at a time and use the longest match possible.
1. Open the lower intake vent to get access to the rear of the refrigerator.
2. Open the valve at the propane gas storage tank.
3. Open the viewing window on the burner box .
4. Turn the mode selector [292] to the GAS (
5. Turn the gas control [294] to the HI position.
6. Push and hold in the gas control.
- In rapid succession, push the igniter [216] in several times.
- Look through the viewing window and make sure that ignition occurred.
Do not hold the gas control in for more than 30 seconds. If there is no flame in this time, wait at least
!
WARNING
five minutes before you try ignition again. If you continue to hold the gas control in, gas will collect
in the burner area. This could cause a fire or an explosion and result in dangerous personal injury or
death.
- Continue to hold the gas control in for about 15 seconds only.
7. Turn the gas control to the amount of cooling that you wish.
8. Close the viewing window on the burner box.

Do a test of the gas safety valve:

With an established flame in GAS mode:
1. Push and turn the gas control to the OFF position (See Art02428).
2. After the flame is extinguished, you should hear a sharp "click" sound within three minutes.
NOTICE
The gas safety valve should close with a sharp "click" sound.
3. Push and turn the gas control to the HI position.
4. Without pushing in the gas control, push the igniter several times rapidly in succession. The burner flame should not ignite. This
means that the gas safety valve is working correctly.
Owner's Manual 6
) position (See Art02428).