Table des Matières
Publicité
®
R&S
RT-ZD40
Adapters
To insert and adjust the adapters
Socket adapter
User Manual 1410.5363.02 ─ 03
Connecting the Probe to the DUT
The socket and browser adapters each consist
of two separate parts: a red one for the posi-
tive socket, and the blue part for the negative
socket. The sockets (socket adapter) or pins
(browser adapter) are mounted off-center, and
the outside is designed like a cogwheel, thus
the distance between the pins can be adjus-
ted.
First, insert one part on the appropriate socket.
Then insert the second part to the other
socket, and make sure that the levers are
symmetrical and the cogs are meshing.
To adjust the distance between the sockets/
pins, turn the levers. A built-in stop prevents
unwanted turning of the signal pins when prob-
ing.
The socket adapter is designed to plug the
probe onto pin strips, or for the connection of
standard accessories.
Distance range: 2 mm to 5.08 mm (80 mil to
200 mil)
The sockets are compatible with 0.64 mm
(25 mil) square pins and 0.6 mm to 0.8 mm
(24 mil to 35 mil) round pins.
24
Publicité
Table des Matières
