Connecting Spool Gun To Handler 210 - Hobart Welders Spool Gun DP 3035 Mode D'emploi

3-3. Connecting Spool Gun To Handler 210

Spool Gun
Ç Ç
Ç Ç
6
MIG Gun
.
Be sure that gun end is tight against drive assembly.
Incorrect
Gun Not Seated
OM-230 261 Page 10
7
3
1
3
Exposed O-rings
will cause shielding
gas leakage.
5
2
4
Correct
Gun Fully Seated
1 Drive Assembly
2 Spool Gun
3 Gun Securing Thumbscrew
4 Gun End
Loosen thumbscrew. Insert end
through opening until it bottoms
against drive assembly. Tighten
thumbscrew.
Spool gun must be inserted
completely to prevent leakage of
shielding gas.
5 Gun Trigger Plug
Insert plug into receptacle, and
tighten threaded collar.
6 Spool Gun/MIG Gun Switch
Place switch in Spool Gun position.
7 Polarity Changeover Terminal
Block
To make proper polarity connection,
see welding power source Owner's
Manual.
Close door.
3
804 695-A