Connecting To Weld Output Terminals - Hobart Welders Champion Elite Manuel Du Propriétaire

5-7. Connecting To Weld Output Terminals

2
6
3
4
5
7 8
.
A complete Parts List is available at www.HobartWelders.com
!
1
!
.
1
2
3
4
5
6
Remove supplied nut from weld out-
put terminal. Slide weld cable terminal
onto weld output terminal and secure
with nut so that weld cable terminal is
tight against copper bar.
7
8
For Direct Current Electrode Positive
(DCEP), connect work cable to Work
terminal and electrode holder cable to
Electrode terminal.
For Direct Current Electrode Negat-
ive (DCEN), reverse cable connec-
tions
Use Process Selector switch to
select type of weld output (see
Section 6-1).
.
Stop engine.
Failure to properly connect
weld cables may cause exces-
sive heat and start a fire, or
damage your machine.
Do not place anything between
weld cable terminal and cop-
per bar. Make sure that the sur-
faces of the weld cable termi-
nal and copper bar are clean.
Correct Weld Cable Installation
Incorrect Weld Cable
Installation
Weld Output Terminal
Supplied Weld Output Terminal
Nut
Weld Cable Terminal
Copper Bar
Work Weld Output Terminal
Electrode Weld Output Terminal
See Sections 6-3for typical pro-
cess connections and control
settings.
Tools Needed:
3/4 in.
244 029-A / 281 080-A / 803 778-B
OM-240 438 Page 25