Installing Exhaust Pipe; Connecting Or Replacing The Battery - Hobart Welders Champion Elite Manuel Du Propriétaire

5-5. Installing Exhaust Pipe

Tools Needed:
1/2 in.

5-6. Connecting Or Replacing the Battery

Tools Needed:
3/8, 1/2 in.
OM-240 438 Page 24
.
A complete Parts List is available at wwwHobartWelders.com
!
Engine backfire can cause se-
vere burns or other injuries. Do
not point exhaust pipe toward
control panel. Keep away from
exhaust outlet.
!
Point exhaust pipe in desired di-
rection but always away from
front panel and direction of trav-
el.
.
Be sure to tighten exhaust clamp
nuts. Exhaust clamp supplied with
muffler.
!
Connect negative (−) battery
cable last.
To connect battery, open right side en-
gine access door.
1 Battery Holddown
To change battery, remove rear panel
with baffle and battery holddown.
Be sure battery cables are not pinched
when installing battery.
−
+
−
+
803 751 / Ref. 281 080-A
1
244 033-A / 244 034-A/ Ref. S-0756-D