Hot Air Ducting; Additional Thermostat Functioning For Ducting Motor Control - Dal Zotto EDY Manuel Utilisateur

HOT AIR DUCTING

Š The pipe destined for ducting the hot air must have an internal diameter of 80 mm, be insulated and protected from heat loss.
Š The length must not exceed 6 metres.
Š Installation of the pipes used for ducting the hot air must be performed by qualified staff and/or the manufacturer's technical after-
sales assistance.
GABRY ELITE
FOR THIS PRODUCT IT IS MANDATORY TO DUCT THE HOT AIR. IT IS NOT POSSIBLE TO DEACTIVATE THE DUCTING
MOTOR. DO NOT COVER OR CLOSE DUCTING!

ADDITIONAL THERMOSTAT FUNCTIONING FOR DUCTING MOTOR CONTROL

For models with ducting motor there is also the possibility of thermostatting the motor itself. The connection of an external thermostat will
allow to control the ducting motor independently from stove functioning.
At this point just set the desired temperature on the thermostat. The thermostat will control the functioning of the second motor:
Š with temperature to be reached (closed contact) the second motor will follow the trend of the stove.
Š when the temperature has been reached (open contact), it takes the ducting motor to 1st speed and will be displayed by the ashing
LED relative to the ducting motor.
The ducting thermostat clamp is tted with jumper as per standard.
40
The ducting extension is found in the accessory pack inside the stove. It is
mounted by means of the 4 supplied screws.
ENGLISH
RITA ELITE