Publicité
Les langues disponibles
Les langues disponibles
Operating Instructions
Operation (Continued)
luBRIcatIon
Air tools require lubrication throughout
the life of the tool and is the owner's
responsibility. Failure to lubricate the air
tool properly will dramatically shorten the
life of the tool and will void the warranty.
BEFORE the initial use and BEFORE and
AFTER each additional use.
AutomAtic lubricAtion
The recommended method for
lubrication is with an air line lubricator
installed as part of the air piping system.
See Figure 1. Use Campbell Hausfeld air
tool oil ST127000AV or equivalent ISO
grade 32 oil.
mAnuAl lubricAtion
If an air line lubricator is not used, the
tool must be lubricated daily.
supply before lubricating.
1. Disconnect the air tool from the air
supply.
2. Turn the air tool upside down.
3. while pulling the trigger, squeeze
approximately a 1/4 oz. of Campbell
Hausfeld airtool oil in the air inlet. If
applicable, switch the forward and
reverse valve in both directions.
lubricated, oil will discharge through
the exhaust port during the first few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
4
This air tool
requires lubrication
Disconnect the
air tool from the air
After an air tool
has been
www.campbellhausfeld.com
4. Connect the air tool to the air supply
and cover the exhaust port with a
towel (refer to replacement parts
manual for tool features). Run the
tool in both the forward and reverse
directions, if applicable, for 20 to 30
seconds. Oil will discharge from the
exhaust port when air pressure is
applied.
opeRatIon
1. Size nose piece to appropriate rivet
mandrel diameter.
2. Place rivet mandrel into nose piece.
3. Insert rivet shank into pre-drilled hole
of materials to be riveted.
4. Squeeze trigger 1 to 2 times until rivet
mandrel breaks off.
5. Tilt tool back until mandrel falls into
safety cap.
RIvet jaw adjustment
1. Hold rivet gun with nose cap pointing
away from self. Remove chrome nose
cap (See Figure 2).
Chrome Nose Cap
Turn jaw
clockwise to
loosen jaws
on rivet
Figure 2
Turn jaw counter-
clockwise to tighten
jaws on rivet
Publicité
