Budda Superdrive Serie Mode D'emploi page 18

Rear Panel Functions: What they do and how to use them
Effects Loop: Superdrive amps have passive series loops. This is where you plug in your effects
devices.
Send: Use this jack to send your signal to an external effect unit input, or to another amplifier's effects
return input. This signal comes from the preamp and includes the EQ section and Master Volume control
of your amplifier.
Return: Use this jack to receive the output of your effects device or another amplifier's send or direct
output. This path sends the signal to the power amp and is post EQ and Master Volume. At this point you
are accessing only the power (output) section of the amplifier.
Slave: The Slave out is a 100-ohm compensated signal that is in parallel with the speaker output. It
contains the full complement of preamp and power amp characteristics of your amp. Use this output to
send your signal to a power amplifier connected to additional speaker cabinets for a louder version of
your amp.
Slave Level: This controls the level of the output from your Slave out. If slaving to an effects unit in a
stereo amp rig, use the unit's input sensitivity LED lights as a gauge to set the slave level. Use this control
to avoid overloading the input of your slave amp or effects unit.
Speakers: This is where you plug in your speaker cabinets.
18