Veripart VPSS103 Manuel D'instructions page 23

• Place back the cover. Make sure it is properly attached.
Attention
• Only use the vacuum cleaner when all filters have been placed. If not, the suction power
could be reduced or the motor could be damaged.
• Torn or not properly sealing filters could damage the motor. When a filter is defective, it
must be replaced by a new original filter.
Cleaning the turbo brush
Hair and/or other dirt can remain in the rotating brush. Therefore,
regularly clean the turbo brush for an optimum use of the vacuum
cleaner.
• Make sure the vacuum cleaner is off and disconnect the turbo
brush from the vacuum cleaner.
• Unlock the catch at the bottom of the turbo brush with a coin or
flat screwdriver.
• Fold out the catch.
• Now carefully pull the brush out of the turbo brush.
• Carefully cut the entangled threads or hairs from the brush.
• Clean the brush with lukewarm running water and allow the brush
to dry in the air.
• Place the brush back in the turbo brush.
• Fold in the catch and rotate it to the locked position with a coin or
flat screwdriver.
Storage
After each use, place the vacuum cleaner back on the suspension bracket. Once the adapter
is connected and the connector is inserted into the connection of the vacuum cleaner, the
battery will charge. Once the battery is fully charged, remove the adapter from the socket
and the appliance.
ATTACHING THE SUSPENSION BRACKET
Use screws and plugs to attach the suspension bracket to the wall on a location near a socket
for the adapter.
• Hold the suspension bracket against the wall at the required position.
• Demarcate the two screw holes on the wall using a pencil.
• Use a drill to make two holes of at least 4 cm deep on the marks.
• Insert the plugs in the holes.
• Place the suspension bracket on the wall and fasten it with the screws.
2 3