Maintenance - Veripart VPSS103 Manuel D'instructions

6. MAINTENANCE

Regularly check the filters to prevent problems. Empty the dust reservoir when it is full and
clean or replace the filters when they are dirty.
Emptying the dust reservoir
It is recommended emptying the dust reservoir after each use. The
dust reservoir is full when the amount of dirt has reached the max
line. Remove the accessories prior to emptying the dust reservoir.
• Hold the vacuum cleaner above a waste bin and open the cover of
the dust reservoir by pressing the knob.
• The cover falls open. Gently shake the dust reservoir empty into
the waste bin and close the cover in such a way that it snaps in
place.
Cleaning the cyclone system and filters
First remove the accessories and empty the dust reservoir before cleaning the vacuum
cleaner. Clean the filters and cyclone system after each 4th time that the dust reservoir is
emptied.
• Press the knob to disconnect the dust reservoir and remove the dust
reservoir from the vacuum cleaner.
• The entire dust reservoir comes away from the vacuum cleaner.
Make sure you hold the dust reservoir upright to prevent the filter
and cyclone system from falling out.
• Remove the filter (a) and cyclone system (b and c) from the dust
reservoir.
• Clean the filter and cyclone system with lukewarm running water
and allow the components to dry in the air. Do not use cleaning
agents or brushes. It is possible that the filter does not return to its
original colour after cleaning. This discolouration does not have an
effect on its function.
• The cyclone system consists of two parts (b and c). In order to
clean the cyclone system thoroughly, you can dismantle the
cyclone system. Clean the parts with lukewarm running water. Do
not use cleaning agents or brushes. Allow the parts to dry in the
air.
• Re-assemble all parts when everything is fully dry and place them
back in the dust reservoir in reverse order.
Caution: the cyclone system fits in the dust reservoir in only one way.
• Properly connect the dust reservoir to the vacuum cleaner and make sure it snaps in place.
Cleaning the HEPA filter
• Unscrew the cover (d) of the air outlet and remove it.
• Remove the HEPA filter from the motor.
• Clean the HEPA filter with lukewarm flowing water and allow the
filter to dry in the air for 24 hours. Do not use cleaning agents or
brushes.
• Only place the HEPA filter back once it is fully dry, or place a new
HEPA filter.
2 2
a
b
c
d