Geberit KSS-160 Manuel D'utilisation page 15

Operation
Geberit pipes and fittings
WARNING
Risk of injury from burns
Risk of burns from hot Geberit welding
plate.
▶ Do not touch the welding plate during
operation or during the cooling-down
phase.
▶ Wear protective gloves.
▶ Insert the welding plate into the provided
stand during breaks in work.
1
Connect the mains plug to the power supply
system.
Geberit KSS-160/KSS-200/KSS-315 welding
plate: The signal lamp flashes red during the
heat-up phase. The signal lamp lights up
green as soon as the welding temperature is
reached.
9083854987 © 10-2021
970.901.00.0(00)
2
Cut pipes or fittings to length at a right angle
and clean heavily soiled surfaces.
Heating the pipes or fittings:
• d32 only by hand
• d40–75 by hand or with a Geberit welding
machine
• d90–315 only with a Geberit welding
machine
3
Heat pipes or fittings by pressing the side to
be welded against the Geberit welded plate
with the required contact pressure.
Connecting the pipes or fittings:
• d32 only on the jointing guide
• d40–75 on the jointing guide or with a
Geberit welding machine
• d90–315 only with a Geberit welding
machine
4
To achieve a high-tensile joint between
pipes and fittings, apply even pressure to
bond the pipes or fittings together
immediately after heating.
EN
15