Toshiba RBC-IR2-PE Mode D'emploi page 4

K7020 Modular Multi Infra Red
GB
Names and Functions of Controls
3
1 2
6
4
5
9
7 8
1. Transmission Indicator
This transmission indicator lights
when remote controller transmits
signals to the indoor unit.
2. ON/OFF Display
Displayed by pushing the
START/STOP button.
3. MODE Display
Displays current operation mode.
6
All manuals and user guides at all-guides.com
12/1/01 11:04 am Page 6
4. TEMP Display
Displays the temperature setting
(17°C to 30°C).
When you set the operating mode to
FAN ONLY or AUTO, no temperature
setting is displayed.
5. FAN Speed Display
Displays the selected fan speed.
Displays AUTO when the operating
mode is either AUTO or DRY.
6. CLOCK and TIMER Display
The current time is indicated. Also
time set for timer operation is
indicated.
7. Reset Button
For resetting transmitter from service
mode.
8. Clock Adjust
For adjusting the clock.
9. Service Mode
Push switch for more than 3 seconds
to enter Service Mode.
Display will be replaced with 00.
GB
Names and Functions of Controls
4. REMOTE CONTROL
8 1
Remote mode.
OPERATION
5. AUTOMATIC (Mode)
2
Operates at last preset condition
DEFROST
(in case transmitter is lost).
3
TIMER
6. TEST COOL (Mode)
4
REMOTE-CONTROL Forced cooling operation
(test mode only).
5
7. INFRARED RECEIVER
6
COOL AUTO
8. BUZZER
MANUAL-CONTROL
7
The receiver on the wall mounted
unit is positioned behind the lens
marked with the Toshiba logo.
RECEIVER
To gain access to the receiver, insert
(on Indoor Unit)
a finger into the recess either side of
the lens and withdraw the lens from
the control panel.
1. RED Lamp
To refit the lens, align both tabs with
OFF: Unit off the rectangular holes in the control
ON: Unit operating normally panel, ensuring the Toshiba logo is
FLASH: Initial system turn on.
correctly positioned, and push the
lens in place.
2. GREEN Lamp
ON: Preheat/Defrost
3. AMBER Lamp
ON: Timer set
FLASH: Service mode
NOTE: All three lamps flashing
indicates system failure. Contact
service engineer.
7