Bosch DHU635HZA Notice D'utilisation Et De Montage page 13

For circulating-air mode:
4.
Secure the cover on the air outlet to the top of
‒
the appliance.
Preparing the drill jig
You can install the exhaust pipe to the upper side of
the appliance.
Requirement: The unit is suitable for the installation.
→ "Checking the unit", Page 12
Cover the hob to prevent damage.
1.
Ensure that the fitted unit is still stable after the cut-
2.
outs have been made.
If the appliance is 60 cm wide, cut the drill jig to
3.
size laterally.
If the appliance is secured to the upper cabinet, cut
4.
the drill jig to size in accordance with the following
diagram.
All manuals and user guides at all-guides.com
5.
Securing the appliance to the upper cabinet
1.
2.
3.
4.
Securing the appliance to the wall
1.
If the appliance is mounted on the wall, cut the drill
jig to size, in accordance with the following diagram.
Use the drill jig to mark where the holes are to be
drilled and drill the holes.
For operation in air extraction mode, create the
opening for the exhaust pipe in the base of the cab-
inet.
Position the appliance underneath the upper cab-
inet.
Use four screws to screw the appliance in from
above.
Ensure that there are no electrical wires, gas pipes
or water pipes in the area where holes are to be
drilled.
Installation instructions en
13