hergom ELEVATE Instructions D'installation, De Service Et De Maintenance page 30

B. - Functioning of the forced convection
Connected to the ventilator network, this will function according to the following guidelines:
Regulator switch in OFF position
The ventilator will start automatically when the temperature registered on the contact
thermostat reaches 50ºC and its speed will be determined by the position on the power
regulator at that time.
When the temperature goes below 50ºC, the ventilator will stop.
Regulator switch in ON position
E- The ventilator will function at all times irrespective of the temperature and at the speed
determined by the power regulator.
F- Electric diagram of ventilator
Azul
Marrón
Amarillo-verde
Azul
Marrón
Negro
E. - Characteristics of the ventilator, curve.
The longitude and diameter of the air conduction tubes influence
fuel wastage and when the volume of flow of useful air transported
decreases, fuel wastage increases, for this reason this must be
taken into account when creating the air system. To do this
correctly the ventilator curve is needed. On the ordinates, fuel
wastage is represented in mm.c.a. and the volume of flow on the
3
horizontal axis in m
Fig. - 17
/h.
Manguera de red.
Azul
Marrón
Amarillo-verde
Motor tangencial EBMPAPST "D2E097-BK80-48"
Sentido del giro del motor
Condensador
Negro
Manguera del ventilador
Azul
Marrón
Marrón
Azul
1 2 3
Blanco (Condensador)
Marrón
Azul
Negro
Amarillo-verde
Fig.- 18