Connecting The Cables - Sharp AN-SV100T Mode D'emploi

Connecting the Cables

Plug the power cord of the ceiling-mount rotating module into the AC
socket on the rear of the projector. Then plug the power cord supplied with
the projector into the AC socket on the module and into a socket-outlet.
Cut off the caps attached to the terminals you use. (You do not have to
remove the caps for the terminals you do not use.)
Connect the cables to the terminals of the ceiling-mount rotating
module. (Do not make connections the cables to the terminals of the
projector.)
Note
• Do not connect the cables to the terminals of the projector.
21