Installing The Projector On The Ceiling Mount - Sharp AN-SV100T Mode D'emploi

Installing the Projector on the Ceiling Mount

Install the projector on the ceiling mount.
Line up the cut-out parts on the installation adapter with the bottom
of the height-adjusting pole, and hang the projector on the pole.
Height-adjusting pole
Caution
• Be sure the projector does not fall out of place.
Until properly anchored, the projector will remain freely suspended from the pole.
Screw in the vertical-angle adjustment bolts enough that they do not
fall out of place (two on each the left and right sides).
Vertical-angle adjustment
bolts M6 (12 mm)
• Adjust the projector's vertical angle and then tighten the screws fi rmly.
Basic installation
For details on the correlation between projecting distance and display size, refer to the projector
operation manual.
Cut-out parts
Vertical-angle adjustment
bolts M6 (12 mm)
17