Lcd Menu Map - Genicom 38 Serie Guide De Référence Rapide

LCD MENU MAP

The following are examples of the format of the LCD messages:
>active
Right: 8.500
Right> 8.000
The following abbreviations are used in the LCD menu:
Auto Sw –
Auto switching. Both serial and parallel interfaces are selected.
Char Set -
Character Set. Select either of IBM character sets 1or 2. Applies to
ANSI and Epson as well as to the two IBM emulations.
CPI -
Characters per Inch.
Form Leng
- Form Length.
IntFace
- Interface. Choices are auto switching, serial, or parallel.
LPI
- Lines per Inch.
Msg Lang
- Message Language. The printer can present the LCD messages in
English, Italian, German, Spanish and French.
PrFormat -
Print a Format report. This shows what is in each of the four stored
formats.
PrintStat -
Print a Status sheet. This shows what is in the active format; in
other words, what the printer is set to do right now.
PrMenu -
Printed Menu. The printed menu has more configuration options than
does the LCD menu. See Chapter 4 of the 3870 User's Manual.
PrnRef -
Print Reference. Use to set a top offset and also a left offset to position
printing on the page. See Chapter 7 of the 3870 User's Manual.
Test Prn -
Test Print. This prints a rolling-ASCII pattern that reflects the current
font, margins, line and character spacing, etc.
Wire Impt –
Wire impact. Adjust impact of print head wires on ribbon. Level 4 is
the default. The higher the level number, the greater the impact.
Use higher levels for multi-part forms. Use lower levels for light-
weight forms.
CAUTION: Setting the impact of the print head higher than is
Quick Reference Guide
The current selection on a multiple-choice menu is preceded by
the greater-than symbol (>).
When a number needs to be entered, the current setting is
preceded by a colon :
Then the arrow flashes after ENTER is pressed to save the
change.
necessary can cause unnecessary print head wear.
33
GEK-89604