Regulator Malfunction Message - E.L.M. Leblanc TR 200 Mode D'emploi

6.9 Reprogramming
If you would like to carry out extensive altera-
tions to the programme it might be better to
set the regulator back to the programme pre-
set by the factory and to re-enter all starting
times.
Turn the control knob (n) to the position
the display (e) shows
depress the cancel button C (r).
If all settings, even the time and the day (and
the display language) are to be deleted to-
gether with the starting times, the cancel but-
ton C (r) must be depressed for longer than
10 seconds.
42
until
then briefly
Select day +/–
7

Regulator Malfunction Message

Malfunction remote indicator
(not available with all heating systems)
For heating equipment with Bosch Heatronic,
a malfunction in the heating equipment is rout-
ed to the regulator.
In case of a malfunction of the heating unit
the control light "Heating" (l) indicates.
The display (e) shows:
Check system
17:53 18.0°C
4217-27.1/G
Note: In this case please proceed as stat-
ed in the operating instructions of
the heating unit or contact your lo-
cal expert for heating systems.
TR 200