Jenn-Air JBL800 Mode D'emploi page 11

Ice Crushing Mode
1. Load ice cubes in the blender pitcher, making sure to use ice that is thoroughly
frozen. Break up any large chunks of ice.
2.Touch the "ON" pad on the control panel.The "ON" pad will illuminate and the
WARNING light will flash to indicate that the blender is ready to operate.
3.Touch the "CRUSH" pad on the control panel.The blender will automatically
operate in short bursts to crush the ice.
4. Once the ice is crushed, touch the "OFF" pad on the control panel.
Using the removable pitcher lid cap
1.While blender is off, remove pitcher lid cap by holding
the pitcher jar and pitcher lid down with one had
and twisting and lifting the pitcher lid cap with the
other hand.
2. Use the small opening in the lid to add ingredients to
the blender while the blender is running. Use caution and blend on low speed
while pitcher lid cap is removed.
Be cautious when blending hot foods, as steam or hot vapor can burn skin when the
lid is removed. Covering the lid cap opening with a clean cloth prior to blending will
allow steam to escape and prevent splattering.
Use the cap opening in the lid to vent steam or hot vapor,
however be sure to open the lid and/or lid cap gradually and
direct steam or hot vapor away from hands, face and other
exposed skin.
For best results, blend small amounts of hot liquids and
cover the lid cap opening with a clean cloth. Use the
"PULSE" mode beginning on the lowest speed setting.
CAUTION
10